Wire kit MST 350 (multi)

MST 350 is easy to install, you simply screw the ceiling attachment (see picture 1) up into the ceiling, thread the wire through the hole on the screw cup and then screw it onto the ceiling attachment. The wire is threaded through the quick release lock (see picture 2) that can easily be adjusted in an up-and-down direction. The kit also contains a relief washer that you thread the wire through. You then drill a 5 mm hole where the wire is intended to hang and thread the wire with the relief washer through the hole so that the relief washer is lying against the surface and thus preventing the wire from passing through the hole.

MT 350 can easily be suspended from ventilation pipes, beams, concrete ceilings or similar ceiling solutions.

This solution can support a load of up to 15 kg.

The wire suspension kit contains:

1. 1 x quick release lock with M6 pin 5.5 mm.
2. 1 x 1.2 mm x 4 m wire with end cap.
3. 1x relief washer.
4. 1 x wire lock 3.0 mm.
5. 1 x concrete clip (drill 12 mm).

Article number MST 350